On Tue, 04 Jan 2005 12:11:08 -0700, Kim Lux <
lux@...>
wrote:
> Good question: I've got a similar challenge facing me. A bunch of
> components I need to use are only available as SM and I've never used
> them on hand built boards.
> I'll extend the question: do I need special tools to work with SM
> components for prototype boards ? I'm used to using a chip clip to get
> signals off DIPs. Should I put test headers on SM boards ?
>
you must decide if you want to iron-solder the ICs or use an oven.
for testing headers are a good idea, i think for some smd packages there
are test clips too.
ST