On Fri, 5 Nov 2004 00:50:36 +0100, Manuel Bessler <
pic@...> wrote:
>
> OK, here are a few more shots:
> http://cockpit.varxec.net/tmp/s_img_2704.jpg
> The board after removing the paper under running water.
> You can see two areas where the toner didn't stick well, and the
> borders
> are not well either, but it didn't pose a problem since it was out of
> the way of the "active region".
> This is just a mounting board and was made in just a few minutes.
> I will try a more complex board within the next two weeks hopefully, and
> can then report back on the success or failure.
look forward to it.
That copper ring around the holes is very narrow, unless you have
throughhole plating
you'll have a hard time drilling and soldering, and getting mechanic
stability.
Oblong pads help a great deal.
I also noticed drilling is easier centered if you only leave a
smaller-than-final hole on
the transfer.
ST