--- In
Homebrew_PCBs@yahoogroups.com, "javaguy11111"
<javaguy11111@y...> wrote:
>
> I am using .064 FR4 1oz as well. I use PNP Blue for the transfer. I
> use 30gauge wire with a .015 bit for most through holes and have had
> no problems with getting a good enough alignment. When I align I
use a
> small light table and a microscope.
Like I said, if I tack down before feeding the laminator, it works
fine. I get within 1-2 microns. Aligning the top and bottom isn't
at all an issue - the laminator was pulling the top sheet slightly.