Archive of the former Yahoo!Groups mailing list: Homebrew PCBs
Subject: Has any tried to tilt the boards?
From: "IMService" <imserv@...>
Date: 2002-05-26
Has anyone worked out a tilting table that could be used to tilt the PC boards,
and then to use the corner of a flat end mill? You would have to cut the traces
horizontal, then the vertical ones, but even with a reposition, you might get a
lot of benefit from the edge of a 1/8 or 1/4 cutter vs the center of a V tipped
cutter.
You might get the same effect from angling the spindle, and the table
construction would not get so complicated.
Fred Smith
IMService