Steve,
It is a nice addition to the discussion. I personally don't need to
use IPA anymore. What I need to use is acetone to dissolve the melted
toner. I noticed that it helps if I leave the toner soaked in acetone
and then rub it off, otherwise it is very hard to remove it just by
rubbing it with paper towel. I am afraid that acetone is here to stay
for the removal of hardened toner because any stronger chemical like
Xylene is even worse to be around. I wonder what does ultrasonic
cleaner do the hardened toner?
Mike
--- In Homebrew_PCBs@yahoogroups.com, steve gunsel <gunsel@v...>
wrote:
>
> >Date: Fri, 30 Jul 2004 13:57:41 -0400
> >To: Homebrew_PCBs@yahoogroups.com
> >From: steve gunsel <gunsel@v...>
> >Subject: IPA and acetone
> >
> >ST,
> >
> >Volatility (speed of evaporation) has a lot to do with it.
Volatility and
> >solvency are not the same. Acetone, however, is a potent solvent
for many
> >substances and also happens to be highly volatile. If you dissolve
> >"anything" in the acetone, and allow the acetone to evaporate, the
> >"anything" will be left behind. And acetone evaporates very
quickly - it
> >starts evaporating as soon as it is applied. Nothing on a board
is
> >likely to evaporate faster or it would not be there in the first
> >place. IPA evaporates more slowly so you have a better chance of
removing
> >the IPA with the dissolved residue.
> >
> >Help any?
> >
> >Steve Gunsel
> >Medina, OH
> >
> >>As for the "IPA leaves residue",
> >>it sounds right, but strangely i get holes in the transfer with
acetone
> >>while it is perfect with IPA.
> >>I must try again with 100% same procedure.
> >>
> >>ST
>
>
> ----------
>
>
> ---
> Outgoing mail is certified Virus Free.
> Checked by AVG anti-virus system (http://www.grisoft.com).
> Version: 6.0.732 / Virus Database: 486 - Release Date: 7/29/04
>
>
> [Non-text portions of this message have been removed]