not feasible
Doing something like this is like going backwards with trying to re-invent how to make PCBs not to mention the ink you'd inevitably waste . I think TT is the solution for people who cant or don't want to use a photo etch or hand drawn lines Photo etch or tin plate etch resist are the only ways - besides using an after process electroless copper to keep PTH from being ETH... or the slower milling of traces instead of etching.
JT
.
http://www.soundclick.com/jtsound ----- Original Message -----
From: Richard Mustakos
To: Homebrew_PCBs@yahoogroups.com
Sent: Thursday, July 29, 2004 9:37 PM
Subject: [Homebrew_PCBs] Electroplating for PCB construction
Reading Mike's email on PTH (Re: Markus's machine and old posts)
conductive ink, I got to wondering.
I don't think the ink is conductive enough to make reasonable traces in
it's own right., but is printing a conductive ink onto the surface of
FR-4 and plating it a way to make PCBs?
My understanding of how it works for PTH is that you hook the un etched,
but plated, board to either + or - (I don't know which) and the copper
source plate to the other terminal. The original copper plating allows
current to flow either to or from the conductive ink in the hole (as
well as the rest of the copper), and copper is deposited on the
conductive ink and the existing copper plate.
This leads me to believe (with no empirical evidence) that the entire
area to be plated must be electrically connected. To print a conductive
ink onto the surface of the FR4 and plate it, all the traces must be
interconnected. Is that correct?
If you can print thin enough lines, you could interconnect with a
different line width, at the cost of cutting the then plated lines out
later.
Would it reduce the PS current requirements, since there us so much less
area to plate?
If a board coated with the ink is resistive enough to run through a
laser printer and pick up an image, you could print a mask onto the ink
to shield parts of it from the copper plating solution, and you would
only plate the traces. If that worked, you would not have to worry
about the interconnections, since the ink is conductive enough to
support the plating, and the entire board is covered by the ink. After
the plating, you would strip off the toner and the unplated conductive
ink in some manner.
Any ideas as to the feasibility?
Richard
Be sure to visit the group home and check for new Bookmarks and files:
http://groups.yahoo.com/group/Homebrew_PCBs
Yahoo! Groups Sponsor
ADVERTISEMENT
------------------------------------------------------------------------------
Yahoo! Groups Links
a.. To visit your group on the web, go to:
http://groups.yahoo.com/group/Homebrew_PCBs/
b.. To unsubscribe from this group, send an email to:
Homebrew_PCBs-unsubscribe@yahoogroups.com
c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
[Non-text portions of this message have been removed]