Dave,
As far as a four layer board is concerned, an extensive check on
what's available in the archives and emails with Makrus brought me to
conclusion that a four layer board is not neccesary to my happieness -
I don't need it. For thruholes I took the advise to check thinktink
website and came up with this link:
http://www.thinktink.com/stack/volumes/voli/store/inksup.htm Zero
ohm resistors sound very sweet at this point.
Then I found out that he might have a conductive ink
http://www.thinktink.com/stack/volumes/voli/store/specs/inkspec.htmI think that once we have Ballendo's machine it would be possible to
use that ink to print our own PCBs.
Mike
"Keep the main thing, the main thing"
--- In
Homebrew_PCBs@yahoogroups.com, "Dave Mucha" <dave_mucha@y...>
wrote:
> <snip>
>
> > There are posts in the past of me about the topic where I
describe
> the
> > process mostly step by step. Please bear with me if I'm too lazy
to
> > retype all this. I'm also a bit under pressure since I leave to a
> two
> > week holiday in a couple of hours.
> >
> > Markus
>
> I can search the list in a few minutes and offer post numbers so we
> can all read up while you are on holiday.
>
> Have a wonderful time on Holiday !
>
> Dave