Ballendo,
Thank you for your feedback on Sherline. I got some parts today and I
will be bolting pieces together. Pretty much because it can be done
otherwise I am anxiously waiting for your mill to become available.
Sincerely,
Mike
--- In
Homebrew_PCBs@yahoogroups.com, "ballendo" <ballendo@y...>
wrote:
> >Markus writes:
> >Yet another unuseable machine! The Z Axis sits in a plastic housing
> >with lot's of play. Have you taken the time to read the
manufacturers
> >support forum?
>
> Markus,
>
> No I hadn't... My comments were based on the pictures at their
> website which included work pieces made during a trade show in
> Germany, I think...
>
> Where is their support forum?
>
> I have to add that I looked pretty closely at the extrusion and
> polymer bearing design of these machines, and it certainly appears
> that any looseness or inaccuracy is adjustably remove-able. But it
> may require a bit of work to get it properly adjusted...
>
> I DO think that sometimes you have to be careful when reading a
> support forum, because only the folks who can't solve the problem
on
> their own will write in... The others simply make the adjustments
to
> their machine(s) and work happily and quietly...
>
> I can imagine that more than a few folks will have trouble
> duplicating the results you get with your THP setup; even though
you
> know from your own efforts that it works well...
>
> Thank you for the added information,
>
> Ballendo
>
>
> --- In Homebrew_PCBs@yahoogroups.com, Markus Zingg <m.zingg@n...>
> wrote:
> > >Dave, thank you for commenting. Have a look at this:
> > >www.easgmbh.de/images/Bgs60.jpg I think it was about 1200 euro.
> > >
> > >How hard would it be to make something like that? Parts seem to
be
> > >mostly from a catalog. I don't see the Y-axis motor, maybe it's
> > >hidden behind the Z... ALso, how to contact Ballendo off list so
I
> > >don't irritate Stefan for the n-th time? (is dollar sunken so
LOW?)
> > >
> > >Mike
> >
> > Yet another unuseable machine! The Z Axis sits in a plastic
housing
> > with lot's of play. Have you taken the time to read the
> manufacturers
> > support forum?
> >
> > Markus