--- In
Homebrew_PCBs@yahoogroups.com, John Johnson <johnatl@m...> wrote:
> If you're doing a single sided board, or you can plate your vias
> through,
> you can just print the component outline on paper, then use spray
> adhesive
> to glue it on the top side of the board. Use a needle to punch through
> the holes for component legs. You could also print on label stock and
> stick it on the board, but it's usually a little thicker (and tougher to
> punch the holes through) than paper.
Or use Tshirt transfers. It's clear, and easy to poke holes through.
Looks a lot better than a chunk of paper.
Steve