On Fri, 28 May 2004 11:58:39 -0000, leon_heller <
leon_heller@...>
wrote:
> I've just uploaded a pic of my latest efforts using an HP LaserJet 5P
> to produce photo-etch artwork on tracing paper:
>
> Photos>Leon's>Photo-etch PCB made with HP 5P
>
> PCB material is Fotoboard (fibreglass/paper laminate) and the board
> was etched in hot FeCl3 with continuous agitation. It took about 5
> minutes. Tracks are conservative - 12 mils.
>
> I'll be tryimng that lead-free solder I mentioned on this board when
> I assemble it. It's actually a simple PIC ISP programmer (PARPIC)
> driven from the PC printer port.
>
> Leon
Nice...
you might consider making tha pads bigger, it will be hard to drill/solder
them.
It might also be that just the hole is too big so it looks a bit odd..
anyway, looks like you could still go down with track with with this
method easily.
ST
please note that only you and the moderator can see the full size picture
in the photo section.
If you have high resolution pictures please store in files.