Thank you.
Ballendo
--- In
Homebrew_PCBs@yahoogroups.com, Stefan Trethan
<stefan_trethan@g...> wrote:
> On Mon, 24 May 2004 05:43:28 -0000, ballendo <ballendo@y...> wrote:
>
> > Stefan,
> >
> > What type of copier/printer did you pull your fuser unit from?
> >
> A ricoh unit. any model should work, even printers.
>
> > What temperature do you set it to?
>
> 160 degrees C i think
>
> >
> > I assume you release the tension on the springs so that the
thicker
> > board material gets about the same pressur as the thinner paper
did?
>
> yes, the original pressure did harm the silicone roller, and spread
the
> toner.
>
> ST