Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: [Homebrew_PCBs] Fuser unit conversion steps/instructions/etc.

From: Stefan Trethan <stefan_trethan@...>
Date: 2004-05-24

On Mon, 24 May 2004 05:43:28 -0000, ballendo <ballendo@...> wrote:

> Stefan,
>
> What type of copier/printer did you pull your fuser unit from?
>
A ricoh unit. any model should work, even printers.

> What temperature do you set it to?

160 degrees C i think

>
> I assume you release the tension on the springs so that the thicker
> board material gets about the same pressur as the thinner paper did?

yes, the original pressure did harm the silicone roller, and spread the
toner.

ST