Hi Hans,
I have no problem with etching. I will even say that Proto
board then Perf onto etched PCBoard. Right now the boards I sell
are milled. If sales get higher I will have a run of boards
etched. I don't like the acid method because I have had some
accidents in the past. I feel all methods of making circuit
boards should be discussed. Going from schematic to PCBoard
has several routes also.
John
--- In Homebrew_PCBs@y..., hans@c... wrote:
> Been following all this about perf. boards and milling etc.
>
> I like the idea of milling but it seems the prep. work is
tremendous.
>
> Doing pref. boards then PCB seems like hard labor.
>
> I'd like to have comments as to why pre-sensitzed PCB and etching
is not
> mentioned and what you consider is so bad with it ?
>
> Best Regards
> Hans W