That's interesting - 300 dpi should give you 3&1/3 mil pixels, right?
Is there anything in the driver that might be effecting it? Unless it
is _really_ trying to do 19.xxx mil, in which case the pads are small
enough that you would see the difference between 16&2/3 and 20 mill
centers, and it probably depends on where the pad starts and ends as
to whether is goes big or small.
You might try printing a test pattern with 1 to n mill wide traces,
multiples places, so you can see how each is effected by placement.
Find a size that is stable and stick with it, 6.667 mil widths on 6.67
mils grid, or just don't worry about the width delta. It shouldn't
really effect how well the board works.
Richard
> However - i just tried to print the footprint and my damn printer
seems to
> be at his
> resolution border...
> the pins don't come out evenly spaced.
>
> 300dpi seems not enough, how much dpi has your printer?
>
> I will try to fiddle with the parameters of the driver and also try to
> print to pdf first etc.
> but i fear it is finally the resoultion limit....
>
> ST