I use a shear. Very clean and fast. It makes a complete mess of
phenolic but FR4 is very clean. I dont use phenolic except in
emergencies so it doesn't matter.
I've used a dremel and agree on the routing bit but that makes a
nasty little mess.
--- In
Homebrew_PCBs@yahoogroups.com, "Leon Heller"
<leon_heller@h...> wrote:
>
> ----- Original Message -----
> From: "ggindele" <ggindele@y...>
> To: <Homebrew_PCBs@yahoogroups.com>
> Sent: Friday, April 02, 2004 7:12 PM
> Subject: [Homebrew_PCBs] Dremel bits for cutting panelized PCB?
>
>
> > I wonder if anyone can recommend a dremel bit for cutting
panelized
> > PCB. What's better, a routing bit or the cutting wheel?
>
> I use a Stanley knife to score the board on both sides, then snap
it and
> clean it up with a file. Much quicker than cutting it and the
results are
> quite neat.
>
> Leon