> Solder paste is best applied with a stencil. Unfortunately, laser cut
> ones
> are quite expensive. PCB-Pool is the best source for them, theirs are
> cheaper than anyone else's.
>
> Leon
> --
> Leon Heller, G1HSM
> Email: aqzf13@...
> My low-cost Philips LPC210x ARM development system:
> http://www.geocities.com/leon_heller/lpc2104.html
>
I make mostly one-off circuits.
a stencil would be far too expensive.
I have applied this paste by hand with such a unit where you press a foot
button
and then a small amount, just right for a certain pad size, comes out the
nozzle.
I wonder if it would work to put such a nozzle in place of the plotter
pen, and after each
pen_down press out a certain amount of the paste.
but this adds another whole lot of problems (like aligning....)
st