In a message dated 21-Apr-02 21:30:53 Central Daylight Time,
adam_seychell@... writes:
> The 60 tooth blade in my saw bench
> (Triton 2000) cost a me bit so I was weary about using it on "FR4"
> material knowing how abrasive this stuff can be.
Adam: Know this! It may cut FR4 (G10, etc.) OK, if the blade is properly
sharp and PERFECTLY-concentric, but once you cut 2" of the stuff, even if it
will continue to "do good" on FR4, it is NO good for woodworking (esp.
plywood) until diamond-sharpened, again!
Same with a steel bandsaw blade. A BS will cut FR4 "just fine" for a time,
but after only 1" of cut, it is RUINED for further woodworking!
Jan Rowland, OLD [deleted] who had BEEN there; DONE that!
[Non-text portions of this message have been removed]