Hi John,
In KCam there is a TRAVEL DEPTH and a CUT DEPTH. Make sure
these two numbers are set in your setup. When you import a DXF into
KCam the cut will showup in RED and the TRAVEL will be blue. Make
sure KCam is displaying these two colors. If you are getting all BLUE
or RED lines, setup KCam and import the DXF again.
What bit are you using? How are you making sure it is the
same length all the time?
John
--- In Homebrew_PCBs@y..., "marble_h" <marble_h@y...> wrote:
> To the smarter minds then My self .
>
> Ok here is what I have done so far I have taken the .dfx files and
> removed all the fill that was in it and left only the lines of the
> traces saved as a new DFX file and when I print it out it looks
good
> made G-code with ACE convertor. BUT it mills the while thing out
and
> leaves the traces untouched it now looks like a eched board when I
> checked it out in K cam 3.All I want it to do is mill out the
> traces of the board what have I done wrong. Now remember this is my
> first time I have ever done this ,the board looks good but I do not
> know how this happened . I would like some information on how to
> change the toolpath on makeing this PCB.
>
>
>
> John Brauweiler