Here is an Idea!!!
1- transfer side 1 of pcb
2-use scotch tape to protect side 2 from etching.
3- etch side 1
4- drill a couple of hole for alignment
5-transfer side 2 using alignment holes and common pins
6-use tape to protect side 1 from etching
7-etch side 2
8- LOOK and SMILE!!!
another way I have heard of people doing this is by putting both transfer
papers up to a light and align the two.
then using staples staple the two pieces together like an envelope.
then insert board and transfer I have never tried this but sounds good.
and because you are going through a laminator you may want to replace the
staples with tape perhaps with adhesive on both sides.
just some Ideas
regards
victor
----- Original Message -----
From: "dkesterline" <desterline@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Saturday, January 17, 2004 12:22 AM
Subject: [Homebrew_PCBs] Laminating and alignment
> Looking for other peoples experiance with aligning double sided TT
> through a laminator.
>
> I just tried to laminate my first DS board. I stuck down one side,
> removed the paper so I could drill a couple alignment holes and tried
> laminating the other side. Totaly destroyed the toner on the first
> side.
>
> So what do other people do?
>
> -Denny
>
>
>
> Be sure to visit the group home and check for new Bookmarks and files:
> http://groups.yahoo.com/group/Homebrew_PCBs
>
> Yahoo! Groups Links
>
> To visit your group on the web, go to:
> http://groups.yahoo.com/group/Homebrew_PCBs/
>
> To unsubscribe from this group, send an email to:
> Homebrew_PCBs-unsubscribe@yahoogroups.com
>
> Your use of Yahoo! Groups is subject to:
> http://docs.yahoo.com/info/terms/
>
>