What is the largest size of board you did that way? I challenge you
that a 6"x9" board will not laminate image correctly. I never had a
single problem laminating small boards but it takes some tricky
ironing to make a large board and I have ALMOST 100%. That ALMOST
might be or might not be important, depending on the location of hte
misfit. What you have there is a steady temperature and the pressure,
but the pressure has to be of certain value; too high and the tracks
are flattened. Too low and they won't transfer. Bu different parts of
board require different(-ly applied) pressure, at least that's what
find out. I am sceptical about your contraption until you provide
your comments. Mike
--- In
Homebrew_PCBs@yahoogroups.com, Derryck Croker <derryck@n...>
wrote:
> On 15/1/04 01:28, Art Eckstein at axtein@d... wrote:
>
> > In the testing that I have done with my home built press, I find
that 120 C
> > works just fine with HP 1300 toner.
>
> Laserjet 5M here.
>
> > A quickie web site of how I made my press is located at:
> >
> > http://ns1.dicomm.net/~axtein/PCB/PCB_Press.htm
>
> Nice kit, but it would never fit into my work room :-)
>
> --
> Cheers,
>
> Derryck