Yes, I realized that it was a bit useless question, so I started moving it
to pdf right after posting the message before. Ill put the pdf in the TT8mil
directory.
Pedro
-----Mensaje original-----
De: Stefan Trethan [mailto:
stefan_trethan@...]
Enviado el: viernes, 09 de enero de 2004 18:19
Para:
homebrew_pcbs@yahoogroups.comAsunto: Re: [Homebrew_PCBs] Time magazine pages and a laminator lead to
awesome results --> Pedro
On Fri, 9 Jan 2004 18:14:44 +0100, Pedro Perez de Ayala Rull
<
payala@...> wrote:
> I have sent you a message explaining with very much detail how I make
> the boards, If anyone else is interested I'll post it on the list, or
> hang
> it in the files section, or wherever you find it helpful. The DSC
> laminator
> just was a mistake, I had been looking for drivers for my DSC sony camera
> and had those letters in mind when I wrote the message. The laminator is
> actually a GBC model Docuseal 95P.
>
> I had the same problems with pressure when I did TT with the iron, You
> don't need to apply much pressure, I think the point is in applying even
> pressure. What I really know is that with the laminator I don't have
> those
> problems anymore. Actually I have been able to do a little bit lower than
> 8mil tolerances. The limit I have observed is 3.2 mil wide tracks and 5
> mils
> clearance, but it has been with about 5 sq.inch. boards, so I thought it
> would be difficult to obtain these results in larger boards so I set all
> the
> boards I do to 8-8 mils, which I find is more than fine and can do it
> without complications and with good repeatibility. One thing to keep in
> mind
> is to make pads big enough to make drilling and soldering easy, as Stefan
> suggested.
>
> Pedro
Please, in the files section with it!
If you did write it up, we should at least get most out of
your work..
thx
Be sure to visit the group home and check for new Bookmarks and files:
http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
To visit your group on the web, go to:
http://groups.yahoo.com/group/Homebrew_PCBs/To unsubscribe from this group, send an email to:
Homebrew_PCBs-unsubscribe@yahoogroups.comYour use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/