Great hint, Thank you Leon! Mike
PS Loved your website- very impressive!
--- In
Homebrew_PCBs@yahoogroups.com, "Leon Heller"
<leon_heller@h...> wrote:
>
> ----- Original Message -----
> From: "mikezcnc" <marabu@c...>
> To: <Homebrew_PCBs@yahoogroups.com>
> Sent: Monday, December 29, 2003 11:20 AM
> Subject: [Homebrew_PCBs] Re: How to cut circuit boards? small
correction
>
>
> > Stefan,
> >
> > This is the cutter that feeds the board between two rollers and
cuts
> > it while feeding the board. Very unusual but works like a dream.
Mike
> >
> > --- In Homebrew_PCBs@yahoogroups.com, Stefan Trethan
> > <stefan_trethan@g...> wrote:
> > > On Sun, 28 Dec 2003 06:02:45 -0000, mikezcnc <marabu@c...>
wrote:
> > >
> > > > The said shears cut wonderfully a regular fiberglass board.
> > however, I
> > > > just learned that a Radio Shack-type Prottype Board gets crack
> > terribly.
>
> IIRC SRBP board shears properly if it is heated first. This softens
the
> resin.
>
> Leon
> --
> Leon Heller, G1HSM
> Email: aqzf13@d...
> My low-cost Philips LPC210x ARM development system:
> http://www.geocities.com/leon_heller/lpc2104.html