Hello Stefan,
I was able to achieve an air tight seal on my spray etcher using a
rubber strip that I purchased at an automobile parts store. The strip that
I used was the rubber weather proofing seal for a sun roof. It was
cheap and readily available. Alternatives to this include the rubber
seal for a refigerator or freezer or the weather proofing seal for an
automobile door. I used lexan for the top along with plastic hinges
and plastic bolts. To attach the rubber seal, I used a marine adhesive.
Be advised that spray etchers atomize the etchant, so a good seal
is imperative.
Best regards
Marvin Dickens
Alpharetta, Georgia USA
Stefan Trethan <
stefan_trethan@...> wrote:
Hi!
I'm thinking about my etch tank.
Even if i make a vertical tank how can i make a airtight lid?
I want to keep the etchant in and prevent too much corrosion.
The lid shoud keep all gases in.
it should have a overpressure valve (because of decomposing H2O2, that is
no problem).
Additionally it should prevent spattering.
(when the tiny bubbles (from the h2o2) burst there is etchant splattered
out of the tank.)
The lid ideally should be constructed in a way ensuring any condensed (or
accumulated from splattering) drops
building up will run down in the tank again, and not run off to the side
when i take the lid off.
Now to the problem:
How can i ensure a airtight seal if i make the tank myself.
even if i use silicone to make something like a seal?
Would it work to bend the top of the tank outward to make something like a
flange?
and on that a bead of silicone (nice flat) as a seal?
How to press the lid (with the pcb holder) against it?
The other idea: (horizontal etch tank)
Take a big tupperware container.
(the seals of these containers are tight enough for me i think.)
fill it a inch or so with etchant.
now suspend the pcb (somehow) in mid-etchant.
some holding mechainsm on the lid is needed again.
The whole jar can be mounted to a heavy wood plate, just to make it harder
to knock it over
while removing the lid.
While etching the lid may only rest loosely on the cointainer, this would
be enough to catch the splattes.
To store it away just press on the lid.
Two questions bother me to this idea:
a)is the lid really tight enough
b)is it a problem to etch horizontally (for uniformity?)
in tray etching the edges are faster, but it doesn't cause trouble.
i nudge the jar sometimes to mix the etchant.
I don't really like the idea of a bubbler but mechanic agitation is ok.
(it might be enough to slightly press on the lid of the tupperware
container a few times
to make the etchant mix? assume the pcb is hold to the lid and acts as a
stirring paddle)
Let me know what you think of the idea.
Stefan
Be sure to visit the group home and check for new Bookmarks and files:
http://groups.yahoo.com/group/Homebrew_PCBs Yahoo! Groups Links
To visit your group on the web, go to:
http://groups.yahoo.com/group/Homebrew_PCBs/To unsubscribe from this group, send an email to:
Homebrew_PCBs-unsubscribe@yahoogroups.comYour use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/ Registered Linux User No. 80253
If you use linux, get counted at:
http://www.linuxcounter.org---------------------------------
Do you Yahoo!?
Yahoo! Photos - Get your photo on the big screen in Times Square
[Non-text portions of this message have been removed]