Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: [Homebrew_PCBs] Re: Copper Clad Board

From: "Steve B." <steveb3906@...>
Date: 2016-12-01

I will give the Proxxon drill a thumbs up also.

It does get warm if you run it for 20 minutes at a time though.

Don't over-tighten the little drive belt, it's not necessary.

I have a little light shining on the drill point area and also I found an air pump at the junk store to blow the dust away.

I've drilled several thousand hole with mine. !!



On Wed, Nov 30, 2016 at 10:14 PM, Camillus Blockx camillus_blockx@... [Homebrew_PCBs] <Homebrew_PCBs@yahoogroups.com> wrote:
 

Hi,
A good affordable hobby drill is from PROXON. Sears carry's these but only on ordering.

cb

On 11/30/2016 5:28:39 PM, arvidj@... [Homebrew_PCBs] <homebrew_pcbs@yahoogroups.com > wrote:

 

I bought the Jameco PCB Drill and was quite disappointed. I found it to not be any better than the Dremel Workstation in rigidity and accuracy.