Some great advice here guys, I'll try anything to succeed as for me a nice DIY pcb. is a thing of buty.
I'm looking in to pressing with a laminator but have to do the homework as don't want to buy one no good for the job. I'm from the uk. so wanting to shop around here.
As I said before my first double sided yet simple board eventually came out good enough (other than lining up the tow layers) but it's too expensive probs works out at £3-4 per sheet and I've gone through a pack to get my first board.
As for the drilling I've looked at using a USB. microscope below the table with a crosshair software to view. Any thoughts?
Over the years whilst being a silent observer of this group IVe seen many talk about glossy magazine as a transfer media. But today as I arrived at work I looked to see if we had any glossy coated laser paper, unfortunately not. I need to look and see where to purchase this from and pulsar, I'll give it all a go until I'm happy.
Regards
Mark
On Tuesday, 28 June 2016, M phillis <mark.phillis@...> wrote:
Rod pretty much as I thought before buying press and peel blue at £19 a pack only to find the instruction don't cover what we discus. Mark
On Tuesday, 28 June 2016, 'Brad'
unclefalter@... [Homebrew_PCBs] <
Homebrew_PCBs@yahoogroups.com> wrote:
I thought the whole point of press and peel was that it was supposed to be easy? Not sounding easy! I actually bought a bunch but now am kind of wondering if I might regret it.
I’m finding just printing to Hot Rod Magazine pages and being patient with ironing gives me pretty close to 100% results these days.