a) The best quality cut i get with a circular/table saw.
There are small units with 50 and 100mm blade diameter.
The blade should be a carbide blade for Fiber reinforced pcbs.
With the full material carbide blade you get very smooth accurate cuts.
They have a glossy surface like the pcb top/bottom. no rework needed
(wouldn't make it better).
Looks really just perfect.
b) The common method seems to be what is called "schlagschere" in german.
I forgot the English word and my dictionary doesn't know either.
To find out what i mean look at the following url:
<
http://www.bungard.com/seiten/p-necut.htm#techn>
The cuts are rather rough, i don't like this method.
c) I have read about people using paper cutters but i think the results
will be similar to b).
d) plate shears are useable.
With the ones i have i can cut 1.5mm fr4 easily.
The disadvantage is as you said the board gets warped.
I have to use this method currently because the flimsy motor of my table
saw decided to rather burn then turn. Building a new saw with better motor
is on the "to do" list.
It is fast, and no dust involved. The shears i have seem to cope well with
the glass fibers.
e) i tried diamond blade for padsaw (tile cutting blade).
works but far from perfect.
A padsaw blade works in any case, for some boards.
But i don't think the glass dust is good for the padsaw "piston" bearing.
It is a bit hard to get a really straight cut with a padsaw (for me).
f) other types of saws will work, but a steel blade is dulled fast by glass
fibers.
As a conclusion i suggest the following:
If you want good quality work buy a circular saw with a carbide blade.
I don't know if carbide-populated blades (like for cutting formica coated
wood) work well, never tried.
A full carbide metal blade with rather small teeth works just perfect.
Get yourself such a saw and you will be happy. but it will also set you
back 100€ or so.
For me this is no problem as i use the saw for model building too.
Stefan
On Sat, 20 Dec 2003 21:49:47 -0000, javaguy11111 <
javaguy11111@...>
wrote:
> Any suggestions on cutting circuit boards. I have used a bandsaw, but
> it tends to be slow, dusty and inaccurate. I have tried paper shears,
> but the board tends to get warped and is only good for about two
> inches and it is too hard to cut any further.
>
> I have seen a few references to using a diamond tile saw. They have
> wet tile saws with a diamond blade at home depot for $88 but it seems
> that the blade would get gummed up with epoxy and not cut.
>
>
> Be sure to visit the group home and check for new Bookmarks and files:
> http://groups.yahoo.com/group/Homebrew_PCBs
>
> To unsubscribe from this group, send an email to:
> Homebrew_PCBs-unsubscribe@yahoogroups.com
>
>
>
>
> Yahoo! Groups Links
>
> To visit your group on the web, go to:
> http://groups.yahoo.com/group/Homebrew_PCBs/
>
> To unsubscribe from this group, send an email to:
> Homebrew_PCBs-unsubscribe@yahoogroups.com
>
> Your use of Yahoo! Groups is subject to:
> http://docs.yahoo.com/info/terms/
>
>
>