Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: [Homebrew_PCBs] Re: Substitute for Sodium Persulphate

From: Mark Lerman <mlerman@...>
Date: 2016-05-28

If you use the Beauty Shop peroxide be aware that the etching is violently exothermic. Lots of heat and fumes. The etching goes very fast. Done in seconds. 

I use the drug store version mixed 2:1 with muriatic acid from the hardware store. Instead of immersing the board I use a sponge and gently rub the copper. This allows you to control where you need the etching. Obviously, wear gloves.

I'm not sure who first described this technique, but it gives you good control and only takes a few minutes. It also lets you use a very small amount of etchant.  

Mark

Sent from my iPhone

On May 28, 2016, at 2:53 PM, John Ferrell jferrell13@... [Homebrew_PCBs] <Homebrew_PCBs@yahoogroups.com> wrote:

Read the MDS. It is pretty safe stuff. About a million years ago I was a Lab Tech and HCl was used to wash ink off our hands.
Beauty shop peroxide is about 30% and over $30 per gallon. The drug store stuff works and $1 per Qt. I wash all wounds with the $1 peroxide and some people use it for mouth wash.
It also leaves bleach dot on you clothing.
-- John Ferrell W8CCW Julian NC 27283 It is better to walk alone,than with a crowd going the wrong direction. --Diane Grant