| previous by date | index | next by date |
| previous in topic | topic list | next in topic |
Look for a “brayer.” It is used for inking, for rolling out laminate to be glued down to counter tops and much more. The rubber can be of varying hardness, depending on application. Sounds like a hard rubber would work best.
From: Homebrew_PCBs@yahoogroups.com [mailto:Homebrew_PCBs@yahoogroups.com]
Sent: Saturday, January 30, 2016 11:25 PM
To: Homebrew_PCBs@yahoogroups.com
Subject: Re: [Homebrew_PCBs] Double sided cold toner transfer experiment
Hi Roland
A good idea with the cold laminator, I never thought of it. Thank you.
By the way the roller you are using is a roller to apply ink on linoleum carvings. Probably available in a craft store at your end.
Rgds
Jean-Claude
Am 31.01.2016 um 02:18 schrieb rolohar@... [Homebrew_PCBs]:
Malcom Parker:
Good Idea:
I use a rubber roller.......looks something like a paint roller, only smaller and with a rubber roller instead of
fuzzy felt.
If I had a laminator, I would use it with no heat, just to apply even pressure across the surface.
One pass should be sufficient.
Regards,
Roland F. Harriston, P.D.
∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗