Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: My toner transfer experance

From: me@...
Date: 2016-01-01

Use Scotch Brite pads before and after etching, I add a bit of hand soap.   Scrub under running water.

 Run the board through laminator at least ten time , flipping the board in every direction.

I print on wax paper. Tape a piece smaller than  a sheet of paper to a sheet of paper.  I have found Reynolds brand works the best.