| previous by date | index | next by date |
| previous in topic | topic list | next in topic |
Hi Mark
I made it myself. A smt version, as my stock of Attiny are all in SOIC form factor. Flashed with an AVRisp and compiled with AVR Studio (an old version)
The µC was reacting normaly, gpio output timing were approximately good... but in doubt, I would prefer to flash the controler again to avoid any software problem.
Tomorrow, I'll check again all the wiring .
Marc
Marc,
I'll send it to you tomorrow morning. I've lost track - did I send you the programmed board or did you make one yourself?
Mark
-----Original Message-----
From: "Marc.olanie@... [Homebrew_PCBs]"
Sent: Feb 5, 2015 12:54 PM
To: Homebrew_PCBs@yahoogroups.com
Subject: RE: [Homebrew_PCBs] Re: DLP MCU version troubleshooting, help neededHi Mark
My printer still refuse to print :- /
Meantime, I have received another e260
The toner and drum assembly is not the culprit, both are working on the "new" printer. Neither the power supply unit. After switching the two elements, the modified rig do nothing, the "new" printer works like a charm.
May I ask you to send me the Hex file you use to burn your Attiny ? I'm wondering if the problem is due to a compilation error (bad fuse selected or something like that)
Cheers
Marc