Hi Tim,
I haven't tried printing on brass, but it should work. I'll see if I canfind a brass sheet and give it a try.
Mark
At 06:04 AM 9/5/2014, you wrote:
Hello Mark,
I have been lurking on this site for a while. My main use has been photoetching thin brass or nickel silver sheet for model railway building.Often arranging to etch from both sides of the sheets with a half etch toachieve surface detail as well as outline for the part.
I also have done the occasional PCB etch as needed.
Is it possible to do the DLP onto thin brass or nickel silver sheet inthe range from about 0.005 to 0.020.
Another idea would be to temp bond a thin brass or nickel silver sheetonto a backing sheet, than etch and separate the parts afteretching.
This would help make detailing parts more quickly and easier.
Cheers
Tim