On 19 Aug 2014 10:12:01 -0700, you wrote:
>KeepIt SimpleStupid
>,I sounds like I should be looking at 63/37 paste with lead. Until I get more adept at SMT components, solder bridges are to be avoided.
Get some solder wick to remove bridges, that seems to work better than
anything else. You can sometimes use a vacuum desoldering system, but
that is often very bulky and unable to hit just a few pins.
Mechanically cutting the solder out will stress the pads and pins way
too much. Occasionally, lots of flux and reheating the joint will
work, but you run the risk of the solder migrating up the leads to the
package itself.
Harvey
>
>I'll take a look at chipquick Bi58 at Digikey.com when I get the chance; sounds like a good option.
>
>In looking at the specs for some of the pastes, I noticed that there is an inhalation warning. How do you avoid exposure to the fumes? Are there other hazards to consider?
>
>I appreciate your input on the hot air rework station and LED headlight, I am trying to decide on which items to order.
>
>Thanks.
>
>FP