Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

I am looking forward to the e260 project, and will be picking one up tomorrow for $40 by way of craig's list. I've seen your ATTINY24 MCU-2 schematic and I wonder what it would take to convert the code to an Arduino Pro Mini sketch. Any ideas on that?
Thanks for sharing your work and information.
Regards,
Roger

 

I am hard at work doing an Instructible. Hope to have it on line by the weekend. I've revised it a bit so that no programming or MCU is necessary. It should only take a few hours and there are no critical steps. The last two E260s I bought cost me $45 USD each on ebay, including shipping. I'm trying to get my hands on a cheap E250 to see if that works.

Mark




At 03:24 PM 7/21/2014, you wrote:

I would  - I am intersted but will need a ∗bit∗ of handolding to be sure. A group process would be great for me.


On Mon, Jul 21, 2014 at 1:16 PM, twgray2007@... [Homebrew_PCBs] < Homebrew_PCBs@yahoogroups.com> wrote:

 

When will someone be posting a how-to for this process?  I don't know enough about laser printers to even know where to start on something like this, but I am good at following directions and have years of EE experience so it looks like an interesting project.  Would anyone be interested in making this a group project?

--
Jim Wood
303-249-0889 (cell)