| previous by date | index | next by date |
| previous in topic | topic list | next in topic |
I have used Line Grinder on a couple of boards. It worked well for me but like any software there is some messing around until you get it figured out. It takes your Gerber and makes G-Code for your mill.
http://www.ofitselfso.com/LineGrinder/LineGrinder.php
Craig
---In homebrew_pcbs@yahoogroups.com, <eslavko@...> wrote:Hello...
I looking for isolation mill software. There are few available to do
basic isolation mill or vonroi. But I look for software that can use
different mill cutters (different width).
For example I have 4, 16 and 40 mil cutters.
I wan't to mill isolation trace with biggest mill possible. When there
are not enought space then use smaller mill. So if there are 10 mil
space I should cut 3 pass overlaped with 4 mil cutter but 20 mil space
with just two pass of 14 mil instead at least 5 pass with 4 mil.
I think this is must if I want large cooper area to be removed.
Does somebody know for that one? (I know LPKF mills use that technique)