Is there a preferred laminator for PCB making?
I have been at this for a few weeks and have tried many of the suggested
media and a few of my own. So far the best results have been with
magazine paper after I figured out what people meant by the term.
Hadn't a clue where one could purchase it.
PnP was a big disappointment and about the worst results.
PO label backing was the second best.
I suspect most of the problems are with uniform heat and pressure so the
laminator seems like a good idea.
As a point of interest, Yahoo seems to have really barfed up the Groups
lately and their stock has crashed in my humble opinion.
Thanks
Jack K9ACT
Astronomy, Beer, Cheese, Fiber, Gems,
Nature, Radio, Sheep, Sausage, Silver
http://schmidling.com