Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: [Homebrew_PCBs] RE: Expo Drill Stand 14211

From: "John" <v321uk@...>
Date: 2013-09-28

That's the one I bought 26711.
Small but takes my Expo mini drill.
With the three shafts run out is minimal, fine for my needs.
 
John  
 
 

From: arvidj@...
Sent: Saturday, September 28, 2013 2:38 PM
To: Homebrew_PCBs@yahoogroups.com
Subject: [Homebrew_PCBs] RE: Expo Drill Stand 14211

 

As a follow up to this thread ...


I ordered the Jameco Drill Stand Works with Mini Drill (Part 26702) ...


http://www.jameco.com/webapp/wcs/stores/servlet/ProductDisplay?langId=-1&storeId=10001&catalogId=10001&productId=26711


Note that I did not order the Miniature Drill 12000 RPM associated with it ...


http://www.jameco.com/webapp/wcs/stores/servlet/ProductDisplay?langId=-1&storeId=10001&productId=26702&catalogId=10001&CID=MERCH


because I have a Dremel 4000 and was hoping to use that.


Regretfully the stand is not capable of supporting the Dremel 4000 securely. The Dremel 4000 is just too big and heavy.


I am not sure if I will bother to get the "correct" motor. While I will admit that for $28 plus shipping the stand is reasonably solid I feel the term "will not be solid enough even with the smaller motor" applies.



---In homebrew_pcbs@yahoogroups.com, <v321uk@...> wrote:

Here are some comments I found on the PZ541 
 
http://www.electro-tech-online.com/general-electronics-chat/122682-time-new-drill-stand.html
 
 
 
 

From: arvidj@...
Sent: Thursday, September 05, 2013 4:50 PM
Subject: [Homebrew_PCBs] RE: Expo Drill Stand 14211

 

It appears to be the same as a "PZ541 Vertical Drill Stand".


I do not have either one. Just wanted to pass along an additional set of 'tokens' to Google for information.



--- In homebrew_pcbs@yahoogroups.com, <v321uk@...> wrote:

Does anyone here have experience in using an Expo 14211 mini drill stand?

Intended use occasional PCB making.

Is there much 'run out' ?

Would you recommend it ?
I tried searching the group but cant see a text search only a message number search.
Thanks, John G3UGY