Hi Dave,
Thanks for this information.
I think your attempt to laser print onto copper is doomed to failure.
As far as I know there is no way of transferring the toner from the drum
to any conductive surface.
Can you describe the Heat Toner Transfer Paper you are using?
http://www.ebay.com/bhp/heat-toner-transfer-paperIs it a gummed paper, in which there is a clear coating of perhaps
slightly cracked or crackable hard gum, which can be dissolved in water?
This is traditional dextrin gummed paper, as used in stamps and
lick-to-stick envelope flaps. It is also sold in jars as "flap gum".
If so, I had all sorts of trouble with such paper due to the toner
jumping around the place. This depended on how dry the paper was - too
dry and the toner would not stick to it long enough to be melted into it
by the fuser roller.
Is it something which water will not touch?
In the write-up of your work by Rick Sparber:
http://rick.sparber.org/electronics/el.htm Copper Etching with Laser Printed Artwork, by David Pickering
http://rick.sparber.org/electronics/cel.pdfyou mention using the Heat Toner Transfer paper and that after freezing
it, it simply peels off the copper and toner, without any water. I think
this is a most remarkable thing. I plan to order some of this paper.
Thanks Rick for summarizing Dave's technique, as elaborated in these
discussions. I suggest you put a link in your document to this fine
discussion forum / mailing list.
- Robin
On 2013-07-30 10:17 AM, David wrote:
> Hi Robin
> The printer I am using at the moment is the Samsung ML1860
> The fax paper I was using is like the old stuff bit wider than A4 so need to trim it down.
> The wax paper as I call it is wax based but has other undisclosed property's, its marketed as Toner transfer paper.
> If you go on fleebay they have drped the price to £1.28 per 10 sheets incl p/p, the company is offshore or something like that.
> The only bug bare is its delivered rolled up so you need to flaten it down for a couple of days or run it through the laminator warm not hot, to straighten it out.
>
> Regards