--- In
Homebrew_PCBs@yahoogroups.com, Stefan Trethan
<stefan_trethan@g...> wrote:
> Well, it is maybe hard to admit but i am a stupid git.
>
> Toner transfer works MUCH better if you use the right side of the
paper ;-)
> .
>
Welcome to the club. I've been using the clay coated paper with good
results for over a year now, and should have known better. The clay
coated paper tends to fill in any pinholes.
Last week, I picked up a small laminator at Odd Lots for $12.99, to
see if it would work. Unfortunately, it didn't work well with the
clay coated paper, but I remembered reading in the files section
about using the backing sheet from pressure sensitive labels. So i
ran thru a test pattern. Didn't work at all. Then realized, I had
printed on the wrong side of the paper. Success! on the next run.
Myc