I have one of those Dremel stands. Right out of the box
it too was "sloppy" and if left that way it would have broken
bits. All I did to fix that was to tighten all the adjustment
screws for a "slide fit". Now, no wobble, etc.
Charlie
On Sun, 09 Jun 2013 18:44:12 -0000 "a8050266" <
mail4sam@...>
writes:
--- In
Homebrew_PCBs@yahoogroups.com, Stephen Farthing <squirrox@...>
wrote:
> After years of messing around with my dremel I think its about time i
got a
> proper drill press for PCB work. The Dremel drill stand is badly
designed
> in my opinion. It does not hold the drill firmly enough and it flexes.
So
> accuracy is not good enough.
> Regards, Steve
Steve,
[Non-text portions of this message have been removed]