I have brother lasers and I'm sure I did successfully use them for tonor
transfer (but possibly it was an OKI), using contact adhesive book
covering (polyproplene)... but with very varied results. Frankly, a lot
more variable than I could be bothered with. Photoresist works much
better.
The roll of book covering didn't go to waste though, when I print my
artwork onto the tracing paper, I immediately stick a piece of the book
covering over it before I do anything else, otherwise the tonor is too
easily damaged on the tracing paper (especially when trying to align
duplicate prints).
> Andrew Hakman wrote:
Pah, top posting, bottom > Also, the whole issue with top
posting, both are old hat > posting is dumb, because if every
I advocate SIDE POSTING > one used a modern threading email
Let the debate about left or right side posting begin!