This really seems good but it's way too pricey.
We still lokking... (I hope to find one, as I really don't want to write
my own)
On 05/24/2013 08:11 PM, ohmware wrote:
> I can highly recommend PhCNC <http://www.accuratecnc.com/phcncStd.php>. It's a bit pricey ($400-500 depending on Std vs. Pro) but the results are awesome, and it's relatively easy to use (as far as CAM/CNC software goes).
>
> --- In Homebrew_PCBs@yahoogroups.com, "designer_craig" <cs6061@...> wrote:
>> Take a look at Linegrinder --haven't used it in a while, don't know if the current capability allows tool changes, but it does support different cutter diameters.
>>
>> Craig
>>
>> --- In Homebrew_PCBs@yahoogroups.com, Slavko Kocjancic <eslavko@> wrote:
>>> Hello...
>>>
>>> I looking for isolation mill software. There are few available to do
>>> basic isolation mill or vonroi. But I look for software that can use
>>> different mill cutters (different width).
>>> For example I have 4, 16 and 40 mil cutters.
>>>
>>> I wan't to mill isolation trace with biggest mill possible. When there
>>> are not enought space then use smaller mill. So if there are 10 mil
>>> space I should cut 3 pass overlaped with 4 mil cutter but 20 mil space
>>> with just two pass of 14 mil instead at least 5 pass with 4 mil.
>>>
>>> I think this is must if I want large cooper area to be removed.
>>>
>>> Does somebody know for that one? (I know LPKF mills use that technique)
>>>
>>