I can highly recommend PhCNC <
http://www.accuratecnc.com/phcncStd.php>. It's a bit pricey ($400-500 depending on Std vs. Pro) but the results are awesome, and it's relatively easy to use (as far as CAM/CNC software goes).
--- In Homebrew_PCBs@yahoogroups.com, "designer_craig" <cs6061@...> wrote:
>
> Take a look at Linegrinder --haven't used it in a while, don't know if the current capability allows tool changes, but it does support different cutter diameters.
>
> Craig
>
> --- In Homebrew_PCBs@yahoogroups.com, Slavko Kocjancic <eslavko@> wrote:
> >
> > Hello...
> >
> > I looking for isolation mill software. There are few available to do
> > basic isolation mill or vonroi. But I look for software that can use
> > different mill cutters (different width).
> > For example I have 4, 16 and 40 mil cutters.
> >
> > I wan't to mill isolation trace with biggest mill possible. When there
> > are not enought space then use smaller mill. So if there are 10 mil
> > space I should cut 3 pass overlaped with 4 mil cutter but 20 mil space
> > with just two pass of 14 mil instead at least 5 pass with 4 mil.
> >
> > I think this is must if I want large cooper area to be removed.
> >
> > Does somebody know for that one? (I know LPKF mills use that technique)
> >
>