On 05/23/2013 08:41 AM, Slavko Kocjancic wrote:
> Hello...
>
> I looking for isolation mill software. There are few available to do
> basic isolation mill or vonroi. But I look for software that can use
> different mill cutters (different width).
> For example I have 4, 16 and 40 mil cutters.
>
> I wan't to mill isolation trace with biggest mill possible. When there
> are not enought space then use smaller mill. So if there are 10 mil
> space I should cut 3 pass overlaped with 4 mil cutter but 20 mil space
> with just two pass of 14 mil instead at least 5 pass with 4 mil.
>
> I think this is must if I want large cooper area to be removed.
>
> Does somebody know for that one? (I know LPKF mills use that technique)
>
<
http://www.cnczone.com/forums/pcb_milling/100359-new_pcb_isolation_milling_software_beta_verison.html>
Try this one, personally, I etch my boards, do nit like the wear and
tear of the bits and machine components due to the glass dust that is
inavoidable during milling FR-4
--
Best Regards,
Q Systems
Zoran A. Šćepanović
zastos@...Skype: zoran.a.scepanovic
http://zastos.com+381 63 609-993
-..-
The rich get rich, and the poor get poorer.