You could always use dry film rather than pre-sensitised, sellers can
supply a length cut from roll, the rolls are 30cm wide which would be
the limit for your long-edge of the board. Use a laminator to apply
it. Laminate a few boards in a run, and store in a dark place until you
need them. Developer is just Sodium Carbonate, a couple of bucks for a
kg at your supermarket would last a long time (mix 20g to 1 liter for
developing).
On 02/04/13 13:08, utriversong wrote:
>
> Hello, please forgive me if this has been covered before. I have been
> making printed circuit boards for a long time now in small scale
> production, but I need to go cheaper, faster and even bigger.
>
[Non-text portions of this message have been removed]