Bosch Colt with a precision collet?
Haven't used them myself, but may work for you:
http://www.precisebits.com/products/equipment/bosch_colt_collets_nuts.asp-Pete
On Mar 11, 2013, at 8:36 PM, Jeff Heiss <jeff.heiss@...> wrote:
> I am drilling holes with #96 (0.006 inch) drill bits. However, not one hole
> has been drilled because the bits are so small compared to the runout of the
> tool, they break in half when they touch the workpiece before any drilling
> begins. Copper clad is my workpiece.
>
>
>
> I tried a Dremel, Dremel flex handpiece, and Marathon 35k RPM micromotor.
> All three have too much runout and the bit breaks in half. Has anyone
> successfully drilled holes this small before? Are there any suggestions for
> a drill or rotary tool that has low runout?
>
>
>
> Jeff
>
[Non-text portions of this message have been removed]