No, but it isn't that expensive, either. Another (free) alternative,
as has been mentioned before is Linux and linuxcnc. You would have to
become familiar with Linux if you haven't used it (I haven't), but it
should be pretty easy if you are only using it for one program.
I just ordered a 3 axis controller on ebay ($42 USD including
shipping), though I think I could use the parts from the on-board
controller to make my own controller, especially if I use the parallel port.
Mark
At 02:51 PM 3/3/2013, you wrote:
>Unfortunately it doesn't look like it's free anymore.
>
>
>--- In Homebrew_PCBs@yahoogroups.com, Cristian <bip@...> wrote:
> >
> > Kcam4 is free and good for controlling a standard stepper driver.
> > Cristian
> >
>
>
>
>
>------------------------------------
>
>Be sure to visit the group home and check for new Links, Files, and Photos:
>http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
>
>
>