> Jeff wrote:
>
> What are opinions on using an electric paint
> sprayer to spray etch a board? Could an electric
> sprayer be modified to run etchant so it can
> resist corroding? Would the spray pattern, droplet
> size, and spray force be acceptable?
Jeff,
Look at
http://www.instructables.com/id/The-Etchinator-low-cost-spray-etcher/The instructable also contains a link to Adam
Seychells more professional etcher (a member
here also)
There are also a few more ideas such as the
splash etcher someone oft mentions here (search
is your friend)
All of them are reasonable ideas. Most of them
would actually be cheaper than an electric
spray paint gun and NOT have corrosion problems.
Ferric Chloride does have its place BTW. Just
not for PCBs unless you don't do them very often.