If you open the unit up. You may be able to use a thin washer to raise one of the rollers where it is mounted.
From: Spencer W
Sent: Sunday, December 30, 2012 3:49 AM
To:
Homebrew_PCBs@yahoogroups.com Subject: Re: [Homebrew_PCBs] laminator
I know with my laminator, if its a thick pcb, when its running through I have to push the board up the end otherwise it will get caught
Sent from my iPhone
On Dec 30, 2012, at 1:50 AM, Mark Schoonover <mailto:mark%40ka6wke.net> wrote:
> When the laminator heats up the rollers expand decreasing the space between
> them. Try running a bare board through first before the one you want to
> transfer.
>
> On Saturday, December 29, 2012, matrice197 <mailto:hololight%40gmail.com> wrote:
>>
>>
>> I am converting a laminator and I have the temp adjusted, as well as the
> height of the roller module (so the PCB can clear the plastic at the
> entrance and exit. The design is two rollers that are not adjustable. When
> the device is cold it will run a board through without a single hiccup....
> but once I turn the heat up to temp it struggles.... I usually have to help
> the board through. Any ideas?
>>
>> Chris
>
> --
> 73 - Mark Schoonover - KA6WKE
> http://www.ka6wke.net
>
>
> [Non-text portions of this message have been removed]
>
>
>
> ------------------------------------
>
> Be sure to visit the group home and check for new Links, Files, and Photos:
> http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
>
>
>
[Non-text portions of this message have been removed]