When the laminator heats up the rollers expand decreasing the space between
them. Try running a bare board through first before the one you want to
transfer.
On Saturday, December 29, 2012, matrice197 <hololight@...> wrote:
>
>
> I am converting a laminator and I have the temp adjusted, as well as the
height of the roller module (so the PCB can clear the plastic at the
entrance and exit. The design is two rollers that are not adjustable. When
the device is cold it will run a board through without a single hiccup....
but once I turn the heat up to temp it struggles.... I usually have to help
the board through. Any ideas?
>
> Chris
>
>
--
73 - Mark Schoonover - KA6WKE
http://www.ka6wke.net
[Non-text portions of this message have been removed]