Ask anyone who has tried to drill out a PCB using standard high speed steel drill bits, or tried to mill a PCB with a high speed steel engraving bit.
If cutting on a tablesaw, I'd strongly recommend a carbide tipped blade. For drilling and milling, again carbide.
Steve Greenfield AE7HD
--- In Homebrew_PCBs@yahoogroups.com, Corey Minion <csminion@...> wrote:
>
> Why would fiberglass dull blades any faster than yellow or red brass or
> any other metal for that matter?
>
> If you want to cut boards on a tablesaw, I would recommend a plastics
> and phenolics ready triple chip grind neg rake blade such as this one
> <
> http://www.toolstoday.com/p-5968-industrial-quality-plastic-cutting-saw-blades.aspx?variantids=10261,0&
> >
>
>
> On 12/21/2012 12:24 PM, Mars Bonfire wrote:
> > I have the equivalent bench shear from Gizzly Tool...but in the 8" size (Grizzly didn't seem to carry the 12" anymore). Looks almost identical to the enco with a somewhat different design for the hold down.
> >
> > If it is the same quality as the Grizzly, it is a great tool. I use it to shear everything from 1/8 plate down through 0.01" brass
> > shim stock. The blades are hard and easily removable for resharpening which should be a snap. It should cut PCB like butter though I hate to dull the blade cutting glass fiber. For cutting PCBs are other plastics I use a Freud Diablo non-ferrous cutting 10" blade on a table saw (carbide, 80 tooth as I recall) it has a very interesting tooth profile and a low, if not negative "hook". Cuts plastic and aluminum plate like butter...virtually no burrs.
> >
> > Steve
> >
> >
>